This Mirage swimming pool instruction guide includes installation instructions for specific items related to the MIRAGE OVAL pool, taken from the 2006 model. All the other steps must be followed in the main instruction manual. Also see instruction guide for the Equinox pool. These pages are for illustration purposes only, full instructions are included in the purchased product.
Insert
the upright base on the front part of the bottom plate (figure 1.1).
Secure
that in place with a 1 inch screw in the upright base opening.
Put
the top of the upright on the wall and insert the wall channel clips.
These clips tighten on the top of the upright by simple pressure and
links the wall, the top channel and the post. (figure 1.2 and 1.3)
Then insert the base cover at the bottom of the upright. (figure 1.4)
Position
and place the top rails as indicated in (figure 2.1). The slots on the top rails
should line up with the holes on the joining plates.
Insert the top 3/4-inch screws (S) without tightening them too much.
Even
the space of each top seat ends to make sure it is centered between the
uprights.
When
all the top rails are installed, wait and fill the pool 2 feet from the top
before continuing to the other step.
Be
sure that the two axis of the uprights are levelled by pushing gently to the
inside before tightening the screws permanently.
Put
the front screws (S) in the lower ends of the top seat and be sure to always
keep levelled the two axis of the post.
Install
all necessary equipment (i.e. skimmer, filter, etc) per manufacturers
specifications.
3- SEAT CAP INSTALLATION (*)
*Note. The two parts of the seat cap will normally be pre-assembled
Insert
the rear central hook (inside of the pool) of the rigid cap on the center tab of
the upright. Install the seat cap
on the front by pulling gently on the part. That will enable the part to lock on
the front tab of the upright. Be
sure that the soft part sits well on the top seats. Then insert the four tabs of
the soft part over the cylinders under the top seat.
Insert the “X-mass tree” fasteners in the holes of those cylinders.
Round Section
Straight side section
AQUA LEADER reserves the right to modify or alter any construction specifications without notice.